WIN WIN S.r.l. Cap. Soc. € 100.000,00 i.v. C.F P.iva e Reg. Impr. CO 03289090130 Operational & Legal Address Via Risorgimento, 8 22044 Inverigo (CO) Italy Tel. +39 031.604111 Fax. +39 031.604399 Drawing, materials and other data are subject to changes prior notice by WinWin S.r.l. All right reserved. Publication is protected by copyright and cannot be reproduced in any part without permission by the Company. Please, be aware that WinWin S.r.l. is the only owner of the know-how of former Cigo Industria Gomma S.r.l. 3. Material The belt is realized in rubber compound and textile/metallic reinforcement Rubber std type Type Breaking strength Elongation at break Hardness Abrasion (DIN 53516) MPa % Shore A mm3 SBR/NR antiabrasive 18 500 65 ± 5 80 Type Breaking strength Working load at 10% breaking strength Load at 1% of elongation Elongation at break N/mm N/mm N/mm % 500/3 3 polyester fabrics 1 metallic breaker 500 50 15 24 400/3 3 polyester fabrics 400 40 12 24 Carcass std type (typical values) 4. Working conditions for standard materials above 5. Research and developments Our Laboratories are always looking for new materials and technologies. BeltTS offer high level of customization and possibility to design unique and special solutions fully compliance with customer requirements. A crew of skilled technicians is always available to provide the necessary support for customized designs and installation on site. Working Conditions Nominal Values Minimum diameter of the pulley 250 mm Temperature resistance 50 °C continuous working temperature 70 °C peaks conditions Oil resistant rubber compound can be used accordingly to the specification requested Our belts, adopting special techniques in the realization of the splice, can also be used on pulleys with diameters up to a minimum dimension of 150mm