Catalog # 203 Description: ZL White Nitrile Smooth Top x Bare FDA International Designation: White Nitrile Smooth Top x FS FDA Item number: 29976 Pulley Diameter, Minimum A) Normal Flex B) Back Flex (76.20 mm) 3.0000 in (152.40 mm) 6.0000 in Construction: Compound Top Cover Smooth White Nit Top Cover Description (1.20 mm) 0.0472 in Top Cover Thickness (in) Bottom Cover Description Friction Surface Compound Bottom Cover Polyester Bottom Cover Thickness (in) (0.00 mm) 0.0000 in Number of Plies 1 Anti Static No Overall Gauge (in) (3.20 mm) 0.1260 in Unit Weight- lb/PIW 0.0683 lbs/PIW Material Between Plies Spiral Polyester Maximum Width (in) 72 in Temperature Range (°F)- High 250 °F Temperature Range (°F)- Low 0 °F Top Cover Shore 65 N/A Bottom Cover Shore Special Characteristics: ZipLink is a breakthrough in belting design that combines time tested rubber cover materials with a structured spiral mesh than can be easily spliced at any length into a continuous belt without the need for special tools. ZipLink's construction eliminates points of weakness because there is no loss of strength at the splice area. The recommended working tension of all ZipLink belts is 150lbs/in with very little stretch to the polyester mesh. This belt is stocked at 72" wide and can easily ship within 3 working days. Pull for 1% Elongation (26 N/mm) 150 lbs/sq in Belt Strength: Splice Instructions: Foil No Splice Process n/a Press Temperature (°F) 0 °F Press Pressure (psi) 0 lbs/sq in Note: Listed above is a guideline only. Every vulcanizer is different and will show different results. We recommend that you do a test splice with your press before attempting the actual belt splice. Other: Cross Rigid High Heat Yes No Impression Top No Oil Resistant Yes Fire Resistant No FDA Approved Yes *****All Values are nominal and subject to change without notice.***** Light Weight Belting Specification Sheet